What GPS devices are supported by your software?
Almost any GPS device equiped with a serial port (RS232, USB or Bluetooth) and supporting the NMEA0183 protocol is supported by the software. The software supports up to 16 channel GPS ......
| Not Rated |
Last Update: 2009-02-13 |
Views: 4 |
|
Does your software performe any GPS datum translation ?
No, we do not. If the GPS outputs WGS84, the Latitude and Longitude returned are still in WGS84. Because most GPS devices use WGS84, the position returned by the GPS SDK ......
| Not Rated |
Last Update: 2009-02-26 |
Views: 3 |
|
Is NMEA2000 supported by your GPS library?
No, at this moment NMEA2000 is not supported, we investigate if it is possible to support this in a next version of the product....
| Not Rated |
Last Update: 2009-02-13 |
Views: 2 |
|
Which projections are currently supported by your Coordinate Calculator ?
The projections are currently supported by both the Eye4Software Calculate Calculator and GPS Toolkit:Transverse MercatorLambert Conformal Conic1SPLambert Conformal Conic 2SPLambert Azimuthal Equal AreaStereographicPolar StereographicAlbers Equal Area ConicCassini SoldnerEckert IVEckert VIKrovakMercatorMollweideOblique MercatorPolyconicPlease ......
| Not Rated |
Last Update: 2009-10-21 |
Views: 2 |
|
What grids are supported by your software ?
All grids using one of the projections below are supported by our software.A list of grids already defined can be found on the following page:http://www.eye4software.com/products/coordinatecalculator/grids/Supported projections:Transverse MercatorLambert Conformal Conic1SPLambert Conformal Conic ......
| Not Rated |
Last Update: 2009-10-21 |
Views: 2 |
|
Do you have a list of ellipsoid defined in your software?
Yes, the list of reference ellipsoids can be found here:http://www.eye4software.com/products/coordinatecalculator/ellipsoids/You can easily add new ellipsoid definitions by yourself.All you need to know is the semi-major axis and the inverse flattening of ......
| Not Rated |
Last Update: 2009-10-21 |
Views: 2 |
|
Do you have a list of geodetic datums defined in your software?
Yes, the list of datums can be found here:http://www.eye4software.com/products/coordinatecalculator/datums/You can easily add new datum definitions by yourself.To add a new geodetic datum, you need the Helmert-7 parameters of this datum.Datums can be managed ......
| Not Rated |
Last Update: 2009-10-21 |
Views: 2 |
|
|
No Last Ten available yet.
|