Eye4Software Hydromagic - Knowledge Base - Tags - Transducer offset
| Q111007 | Where do I configure the horizontal distance between the transducer and GPS antenna? |
| In order to get accurate soundings when GPS antenna and echo sounder transducer are not mounted on the same location, an offset has to be calculated by taking the X and Y offset between the sensors and project this position using the vessels heading.In Hydromagic, the position of the transducer and ... | |
| Tags: Vessel Shape, Transducer offset, Sensor offsets, Heading, Vessel Designer, Vessel Shape Editor |
| Q112004 | Where do I configure the draft in your software? |
| In hydrography, the (static) draft is the offset between the bottom of the echo sounder's transducer and the water surface. This is normally a fixed value and should not change very often. Some echo sounders allow you to define this draft in the echo sounder's configuration.In cases in which it isn' ... | |
| Tags: Transducer offset, draft, dynamic draft, sounder offset |
| Q112006 | Where do I configure the horizontal distance between the transducer and GPS antenna? |
| In order to get accurate soundings when GPS antenna and echo sounder transducer are not mounted on the same location, an offset has to be calculated by taking the X and Y offset between the sensors and project this position using the vessels heading.In Hydromagic, the position of the transducer and ... | |
| Tags: Vessel Shape, Transducer offset, Sensor offsets, Heading, Vessel Designer, Vessel Shape Editor |
| Q130004 | Where do I configure the distance between the transducer and GPS antenna ? |
| In order to get accurate soundings when GPS antenna and echo sounder transducer are not mounted on the same location, an offset has to be calculated by taking the X and Y offset between the sensors and project this position using the vessels heading. In Hydromagic, the position of the transducer ... | |
| Tags: Transducer offset, Sensor offsets, Heading, Vessel Shape, Vessel Designer, Vessel Shape Editor |
| Q140004 | Where do I configure the draft in your software? |
| In hydrography, the (static) draft is the offset between the bottom of the echo sounder's transducer and the water surface. This is normally a fixed value and should not change very often. Some echo sounders allow you to define this draft in the echo sounder's configuration.In cases in which it isn' ... | |
| Tags: Transducer offset, draft, dynamic draft, sounder offset |