Eye4Software Hydromagic - Knowledge Base - Tags draft
| Q112004 | Where do I configure the draft in your software? |
| In hydrography, the (static) draft is the offset between the bottom of the echosounder's transducer and the water surface. This is normally a fixed value and should not change very often. Some echosounders allow you to define this draft in the echosounder's configuration.In cases in which it isn't p ... | |
| Tags: Transducer offset, draft, dynamic draft, sounder offset, |
| Q140004 | Where do I configure the draft in your software? |
| In hydrography, the (static) draft is the offset between the bottom of the echosounder's transducer and the water surface. This is normally a fixed value and should not change very often. Some echosounders allow you to define this draft in the echosounder's configuration.In cases in which it isn't p ... | |
| Tags: Transducer offset, draft, dynamic draft, sounder offset, |
| Q140005 | What do I have to enter for antenna height in the RTK settings? |
| To use RTK tides using a RTK receiver and a geoid model, it is required to set the height of the antenna above the water surface. Please note that you use the phase center of the internal antenna instead of the bottom of the antenna.If you do not configure a draft for the echosounder, it is also pos ... | |
| Tags: tide, RTK, RTK tide, tide calculation, geoid, geoid model, antenna height, water level, vertical datum, draft, static draft, |